Accessories - Makita RP1800 Bedienungsanleitung

Dust nozzle set (Accessory)
1
1. Dust nozzle
2. Clamping screw
009878
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
Then connect a vacuum cleaner to the dust nozzle.
Fig.25
How to use screw M6 x 135 for adjusting the
depth of cut
When using the tool with a router table available in the
market, using this screw allows an operator to obtain a
small amount of adjustment of the depth of cut from
above the table.
Fig.26
1. Installing the screw and washer on the tool
Attach flat washer onto this screw.
•
Insert this screw through a screw hole in the tool
•
base and then screw in the threaded part in the
motor bracket of the tool.
Fig.27
Fig.28
Fig.29
At this time, apply some grease or lubricating oil to the
inside of the screw hole in the tool base and the
threaded part in the motor bracket.
Fig.30
Fig.31
2. Adjusting the depth of cut
A small amount of depth of cut can be obtained by
•
turning this screw with a screwdriver from above
the table. (1.0 mm per a full turn)
Turning it clockwise makes the depth of cut greater
•
and turning it counterclockwise smaller.
Fig.32
2
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
Fig.33
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Fig.34
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10
minutes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If
electric brake is not working well, ask your local Makita
service center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide
•
Trimmer guide
•
Guide holder
•
Templet guides
•
Templet guide adapter
•
Lock nut
•
Collet cone 12 mm, 1/2"
•
Collet sleeve 6 mm, 8 mm, 10 mm
•
Collet sleeve 3/8", 1/4"
•
Wrench 24
•
Vacuum head set
•
11
or attachments
Only use accessory or
are