Installing Auto Iris Lenses; Installing Direct (Or D.c.) Drive Lenses - Honeywell E Serie Installationsanleitung

Installing Auto Iris Lenses

Installing Direct (or D.C.) Drive Lenses

To install a Direct or D.C. Drive Lens:
1. Turn the back focus adjustment ring fully clockwise (when viewed from
the front.)
2. Fit the lens to the camera and rotate clockwise until the lens is fully
screwed into the camera.
If the lens is equipped with a 4-pin connector, plug the connector into
the terminal on the side of the camera.
If the lens is not equipped with the connector, connect it according to
Figure 3 below.
Figure 3
Warning
not exceed 25 mA.
3. Set the Auto Iris selector (see
4. Set the Auto Iris lens selector to DD for Direct Drive lenses.
5. Adjust the back focus using the back focus mounting ring on the front of
the camera. See "Back Focus Adjustment" on page 6.
6. With typical scene illumination, set the ALC Level adjustment
potentiometer (see
be achieved either visually, or by using an oscilloscope to set the output
of the camera to 1 Vp-p.
Rev 2.01
Connector Pinouts (Direct or D.C. Lenses)
Pin # DC drive
1
2
3
4
The maximum load for this type of lens must
Figure
Figure 1), lens iris for the correct exposure. This can
8
Damp -
Damp +
Drive +
Drive -
1) to AI.
Document 900.0323
05/05