Lens Selection; Back Focus Adjustment - Honeywell E Serie Installationsanleitung

Lens Selection

Suitable lens types are C- and CS-mount in fixed iris, manual iris, video auto
iris, or direct drive auto iris versions. Cameras are factory set for CS-mount
lenses.
If using a C-mount lens, rotate the back focus adjustment mechanism fully
clockwise (when viewed from the front of the camera) before fitting the lens.
See "Back Focus Adjustment" on page 6.

Back Focus Adjustment

The back focus adjustment is accessible at the front end of the camera
housing to adjust the back focal length or picture focus.
The range of adjustment allows both C- and CS- mount lenses to be used
without the need for a spacer ring.
To use the back focus mechanism:
1. Unlock the back focus mechanism by loosening the locking screw (see
Figure 2).
Figure 2
Locking screw
Back focus
adjustment
2. Rotate the back focus adjustment ring as required. When viewed from
the front of the camera, clockwise adjustment moves the CCD sensor
away from the back of the lens; counter clockwise adjustment moves
the CCD sensor towards the back of the lens.
3. Tighten the back focus locking screw.
Rev 2.01
Back Focus Adjustment
6 Document 900.0323
05/05