Changing Bits/Screw Driver Bits (See Fig. B); Operation; Switching The Cordless Screwdriver On/Off - Parkside PAS 4 C4 Originalbetriebsanleitung

Start charging
♦ Connect the USB-C plug on the charging
to the charging socket 5.
cable
9b
♦ Connect the USB plug of the charging cable
charger 9.
Connect the charger 9 to a 100–240 V ,∼ 50/60 Hz power
♦
source.
The battery is fully charged when the battery level display 3
changes from red to green.
Stopping charging
Disconnect the charger 9 from the mains power supply.
♦
♦ Disconnect the USB-C plug on the charging cable
charging socket 5.
Changing bits/screw driver bits (see fig. B)
Inserting
♦ Insert the bit into the tool holder
Removal
♦ Pull the bit out of the tool holder

Operation

Switching the cordless screwdriver on/off
Switching on
To start the appliance, press the ON/OFF switch 6 and keep it
♦
pressed in.
│ GB │ IE
■ 14
to the
9a
9b
.
.
from the
PAS 4 C4