Disposal And Recycling; Troubleshooting; Possible Cause - Parkside MPKZ 2000 A1 Originalbetriebsanleitung

14. Disposal and recycling

The equipment is supplied in packaging to prevent it from being damaged in transit. The raw materials in this packaging can be reused or
recycled. The equipment and its accessories are made of various types of material, such as metal and plastic. Defective components must be
disposed of as special waste. Ask your dealer or your local council.
The packaging is wholly composed of environment ally-friendly materials that can be disposed of at a local recycling
centre.
Contact your local refuse disposal authority for more details of how to dispose of your worn-out electrical devices.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be disposed of at a designated
collection point. This can occur, for example, by handing it in at an authorised collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste equipment may have negative consequences for the environment and human
health due to potentially hazardous substances that are often contained in electrical and electronic equipment. By properly disposing of
this product, you are also contributing to the effective use of natural resources. You can obtain information on collection points for waste
equipment from your municipal administration, public waste disposal authority, an authorised body for the disposal of waste electrical and
electronic equipment or your waste disposal company.

15. Troubleshooting

Fault

Possible cause

Motor does not work Motor, cable or plug defective, the mains circuit
breaker switched off
The motor starts up slowly Voltage too low, coils damaged, capacitor burnt
and does not reach oper-
ating speed.
Motor makes excessive Coils damaged, motor defective
noise
The motor does not reach Circuits in the network are overloaded (lamps,
its full power. other motors, etc.)
Motor overheats easily. Overloading of the motor, insufficient cooling of
the motor
Saw cut is rough or wavy Saw blade dull, tooth shape not appropriate for
the material thickness
Workpiece pulls away Excessive cutting pressure and/or saw blade not
and/or splinters suitable for use
12 GB/IE/NI
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary.
Contact an electrician to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a specialist.
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the same
circuit
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor
Re-sharpen saw blade and/or use suitable saw blade
Insert suitable saw blade