Supplied Accessories - Sharp 8M-B120C Einrichtungsanleitung

Accessories

Supplied Accessories

Make sure the following accessories are provided
with the product.
• Remote control unit (x 1)
• Remote control unit battery (x 2)
• AC cord (Type BF) (x 1)
• AC cord (Type C) (x 1)
• AV terminal conversion cable (x 1)
• Cable clamp (x 5)
• Setup Guide (this document) (x 1)
• Stand (x 1 set)*
• Wall mounting bracket (x 1 set)*
• Eyebolt cover (x 2)*
• Eyebolt cover attachment screw (x 2)*
* Consult your dealer for installation of the stand or wall
mounting bracket.
* For environmental protection!
Do not dispose of batteries in household waste. Follow
the disposal instructions for your area.
NOTE
• The supplied AC cord is dedicated for this product. Do not
use it for other equipment.
Preparation and How to Use Remote Control Unit
1
Remote control light
receiving section 30°
17´ (5 m)
30°
30°
18°
EN 4
Inserting Batteries into the Remote
Control Unit
1
Place your finger on the part marked with the s,
and then pull the cover off.
2
See the instructions in the compartment and put
in the batteries (R03 or LR03 ("AAA" size) x 2) with
their plus and minus sides oriented correctly.
(+) (-)
3
Close the cover.
NOTE
• Do not apply impact on the remote control unit. Avoid water
and do not place the product in areas with high humidity.
• If the remote control unit occasionally does not respond, the
batteries may be running out. Replace them ahead of time.
The supplied batteries may run out in a short period of time
depending on the storage condition.
• Use manganese or alkaline batteries only.
• Check the cell batteries of the remote control unit once in
six month for abnormality such as leakage and distortion.
The remote control may not function properly after a
leakage occurs.
Range of Remote Control Operation
• Check the range and distance of both the remote
control unit and the Monitor, and press one button on
the remote control unit at a time.
CAUTION
Do not place objects in the area under the Monitor.
Obstacles may interrupt the receiver of the remote control and
may result in misoperation.