Troubleshooting - Klarstein Hudson Bedienungsanleitung

TROUBLESHOOTING

Problem Possible Cause
Appliance does Temperature regulation knob is
not work set at number "0".
Mains plug is not plugged in
or is loose
Fuse has blown or is defective
Socket is defective
The food is too Temperature is not properly
warm. adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Appliance cools Temperature is set too cold.
too much
Unusual noises Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
Water on the Water drain hole is blocked.
floor
Side panels It's normal. Heat exchange is in
are hot the side panels
Suggested Solution
Set the knob at other number to
switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the installation
location section.
Turn the temperature regulation
knob to a warmer setting
temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
See the Cleaning and Care
section.
Take gloves to touch side
panels if need.
EN
37