Electromagnetic Interference - Sharp GX-BT60 Handbuch

• Should a fault develop with your SHARP product, contact SHARP for advice on how
to proceed.
• Do not attempt to repair or alter any SHARP product yourself.
Approved Accessories
The use of accessories not approved by SHARP, may cause your SHARP device to
malfunction or in the case of non-approved electrical accessories may cause the device
to exceed RF energy exposure guidelines.
Use of non approved accessories will void your device's warranty.

Electromagnetic Interference

Nearly every electronic device is susceptible to electromagnetic interference (EMI) if
inadequately shielded, electromagnetic confi gured for electromagnetic compatibility.
Similar to a mobile phone, your SHARP device is a low power transmitter / receiver and
is covered by regulations pertaining to such devices. Turn off your SHARP device in any
facility where posted notices instruct you to do so. These facilities may include hospitals
or health care facilities that may be using equipment that is sensitive to external RF
energy.
• When instructed to do so, turn off your SHARP device when on board an aircraft. Any
use of a mobile device must be in accordance with applicable laws, regulations and
airline crew instructions.
• Some Bluetooth devices may interfere with some hearing aids. In the event of such
interference, you may want to consult your hearing aid manufacturer or physician to
discuss alternatives.
• If you use any other personal medical device, consult the manufacturer of your device
to determine if it is adequately shielded from RF energy. Your doctor or physician may
be able to assist you in obtaining this information.
• If you are in doubt about whether your SHARP device be safely turned on or
used, please consult an authorised person in the location you want to use your
SHARP device. If no authorised person is available or you remain uncertain, SHARP
recommends that you turn off your Bluetooth device and any mobile phones unless
they are required in an emergency situation.
How to remove the battery for disposal
RISK OF INJURY. WEAR GLOVES WHEN WORKING!
The battery should be removed by an authorized Sharp service centre. Not doing
so will invalidate any guarantees and warranties on your device.
1. Use a fl at screwdriver to gently prize away the fabric cover.
2. Remove the 5 screws with Philips screwdriver on middle plastic cover.
3. Take off the middle plastic part.
EN