Herunterladen Inhalt Inhalt Diese Seite drucken

Starting And Stopping - Husqvarna 570BTS Bedienungsanweisung

Vorschau ausblenden Andere Handbücher für 570BTS:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 183
H1158747-38,570BTS, 580BTS_1.fm Page 16 Wednesday, January 25, 2017 11:09 AM

Starting and stopping

WARNING! Always move the machine
!
away from the refuelling area and source
before starting. Place the machine on a
flat surface.
Make sure no unauthorised persons are in
the working area. Otherwise there is a risk
of serious personal injury. The safety
distance is 15 meters.
The machine may only be started in its
complete design. If the machine is started
without all the guards fitted there is a risk
of personal injuries.
Cold engine
Ignition: Set the stop switch to the start position. About
one third open.
(2)
(3)
(4)
(1)
1
Full throttle
2
About one third open.
3
Idle speed
4
Stop switch
It is not allowed to set the stop switch in full throttle
position.
Choke: Set the choke control in the choke position.
Primer bulb: Press the air purge repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
Warm engine
Use the same starting procedure as for a cold engine but
without setting the choke control in the choke position.
16 – English
STARTING AND STOPPING
Starting
Hold the body of the machine on the ground using your
left hand (CAUTION! Not with your foot!). Grip the starter
handle, slowly pull out the cord with your right hand until
you feel some resistance (the starter pawls grip), now
quickly and powerfully pull the cord.
Never twist the starter cord around your hand.
Repeat pulling the cord until the engine starts. When the
engine starts, return choke control to run position.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
NOTE!
Air is released as soon as the engine is started, even
when idling.
When the engine fails to start after several attempts due
to overchocking, open the choke and repeat pulling the
rope.
Set the required engine speed with the throttle control.
1
2
3
4
Stopping
The engine is stopped by moving the stop switch to the
stop position.
(2)
(3)
(4)
(1)
Full throttle
About one third open.
Idle speed
Stop switch

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

580bts

Inhaltsverzeichnis