Fitting The Sanding Sheet Onto The Sanding Plate; Operation; Switching On And Off; Selecting Oscillation Speed - Parkside 276381 Originalbetriebsanleitung

Fitting the sanding sheet onto the
sanding plate
Attaching:
♦ Sanding sheets are attached to the sanding
pad by means of the hook and pile fastening.
NOTE
► Before fitting a new sanding sheet
any dust and dirt from the sanding pad
► Note that the holes for dust extraction from
sanding sheet and sanding pad
aligned.
♦ Position the sanding sheet
of the sanding pad
sheet on the sanding plate.

Operation

Switching on and off
Switching on:
♦ Push the ON/OFF switch
the appliance on.
Switching off:
♦ Push the ON/OFF switch
switch the appliance off.

Selecting oscillation speed

♦ Use the speed adjustment wheel
required oscillation speed.
Level 1: low speed
Level 6: high speed
NOTE
► The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests.
■ 20 │ GB
, remove
.
are
flush on one side
, then place the sanding
forwards to switch
backwards to
to set the

Maintenance and cleaning

WARNING! RISK OF INJURY!
Always remove the plug from the
power socket before working on the
power tool.
■ Do not use any sharp objects to clean the ap-
pliance. Do not allow any liquids to get into the
appliance. This can damage the appliance.
■ Clean the appliance regularly, preferably
immediately after completion of the work.
■ Clean the housing with a dry cloth – do NOT
use petrol, solvents or cleaners that can attack
the plastic.
■ A vacuum cleaner is required for thorough
cleaning of the appliance.
■ Ventilation openings must never be obstructed.
■ Remove any adhering grinding dust with a
brush.
NOTE
► Replacement parts not listed (such as carbon
brushes, switches and replacement batteries)
can be ordered via our service hotline.
PMFW 310 C2