Operation
Switching on:
Press the ON / OFF switch
Switching off:
Release the ON / OFF switch
Setting the stroke rate
The stroke switch
ing. A low setting is normally adequate for most engraving tasks.
Turn the switch for the number of strokes
increase the penetration depth.
Turn the switch for the number of strokes
decrease the penetration depth.
Note: Take care when increasing the penetration depth that you do
not turn the stroke switch
switch could screw off the device.
Changing the engraving point
performing any tasks on the device and pull the mains plug out of the
mains socket.
Replace the engraving point
and no longer provides the desired engraving performance. Turn
the engraving point holder
point
14 GB/CY
Downloaded from
www.Manualslib.com
is used to set the penetration depth of the engrav-
2
2
RISK OF INJURY! Switch the device off before
is released.
5
manuals search engine
.
1
.
1
2
2
too far in the + direction. Otherwise the
as soon as it becomes too worn
5
anticlockwise until the engraving
6
in the + direction to
in the – direction to