Dtv Programme Timer Setting; Setting Up Digital Tv Channels Manually; Adding New Channels; Checking Signal Strength - Pioneer PDP-505XDE Dtv-Bedienungsanleitung

Enjoying DTV broadcasts

DTV Programme Timer Setting

With the Programme Timer list you can sort the order of
programmes or delete programmes that are preset for
recording/watching.
1
Press HOME MENU.
2
Select "Setup" ( /
3
Select "DTV Setup" ( /
4
Select "Programme Timer" ( /
5
Set the start and end time of preset recording/watching
and the channel number ( / ,
after all desired settings are made (ENTER).

Setting up digital TV channels manually

This section describes how to add new digital TV channels.

Adding New Channels

You can scan the new TV channels and download them to
your Plasma Display System.
1
Press HOME MENU.
2
Select "Setup" ( /
3
Select "DTV Setup" ( /
4
Select "Installation" ( /
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
5
Select "Add New Channels" ( /
Installation
Aerial Power
Country
Add New Channels
Replace Existing Channels
Signal Check
Restore System Defaults
• Channel search automatically starts.
Add New Channels
Search Information
Existing Channels
New Channels Found
Progress
• To quit a channel search in progress, press HOME
MENU.
Downloaded from www.Manualslib.com
then ENTER).
then ENTER).
then ENTER).
/
or 0 – 9). Register
then ENTER).
then ENTER).
then ENTER).
then ENTER).
Off
Germany
Found Channels
04 001
************
20 002
************
30% 003
******
004
************
manuals search engine

Checking signal strength

You can check the signal strength and signal quality of each
TV channel.
1
Repeat steps 1 to 4 provided for Adding New
Channels.
2
Select "Signal Check" ( /
3
Select "RF Channel" ( /
4
Select the channel to be checked (
Signal Check
RF Channel
Add New Channels
Signal Strength : 77%
0 25
Signal Quality : 100% Good
• Use "Add New Channels" function here to add
channels within the selected RF Channel (receiving
frequency).

Setting Aerial Power

The power supply to the antenna connected to the DTV
antenna terminal can be switched on or off.
1
Repeat steps 1 to 4 provided for Adding New
Channels.
2
Select "Aerial Power" ( / ).
3
/
Select "On" or "Off" (
Installation
Aerial Power
Country
Add New Channels
Replace Existing Channels
Signal Check
Restore System Defaults

Restoring System Defaults

Use this function only when you wish to reset all the DTV
settings to the factory defaults.
1
Press HOME MENU.
2
Select "Setup" ( / then ENTER).
3
Select "DTV Setup" ( /
4
Select "Installation" ( /
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
5
Select "Restore System Defaults" ( /
• A confirmation screen appears.
6
With "OK" pressed, the system restores the factory
defaults. After this Auto Installation is initiated
automatically.
then ENTER).
then ENTER).
/
).
21
50 75 100
).
Off
Germany
then ENTER).
then ENTER).
then ENTER).
01
5
En