Herunterladen Diese Seite drucken

Cleaning; General Maintenance; Removal Of Clogging And Blockage - Parkside PLSA 40-Li B1 Originalbetriebsanleitung

Akku-laubsauger/-bläser

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
GB
IE
Switch off the device and remove
the battery from the device before
working with or transporting it.
Turn off the appliance and, before doing
any servicing and remove the mains plug
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the device.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or sol-
vents. You may otherwise irreparably
damage the appliance.
Clean the collection bag (
a brush and, if needed, compressed
air.

General maintenance

• Prior to every use, check the appliance
for obvious defects such as loose, worn
or damaged parts.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
38
Removal of clogging
and blockage
Leaf material and fresh plant parts may
clog / block the device.
Cleaning the impeller wheel:
1. Open the protective cover (
2. Carefully remove residues or clogging
3. Check to make sure the impeller wheel
4. Close the protective cover (
15) using
A
Remove the batteries from the de-
vice! Risk of injury!
remove the suction pipe (
section "Assembling/dismantling the
three-piece suction pipe" and/or "As-
sembling/dismantling the three-piece
blowpipe".
materials from the impeller wheel.
is easier to turn and is in undamaged
condition. Have our Service Centre re-
place a defective impeller wheel.
screw the suction pipe (
into place.
See section "Assembling/dismantling
the three-piece suction pipe" and/
or "Assembling/dismantling the three-
piece blowpipe".
If the protective cover (
or the suction pipe (
correctly screwed into place, it is
not possible to operate the device.
7) or
16). See
7) or
16) back
7) and/
16) is not

Werbung

loading

Diese Anleitung auch für:

Ian 339929_1910