Installing/Removing The Collection Bag; Putting On The Carrying Strap; Operation; Switching On And Off - Parkside PLSA 40-Li B1 Originalbetriebsanleitung

Installing/removing the
collection bag
In suction mode the device
must only be operated with
the collection bag mounted.
The ventilation opening on the collection bag
(20) serves for an improved air circulation.
1. If necessary, remove the blowpipe
( 9) (see "Assembling/dismantling
the three-piece blowpipe").
2. Now push the collection bag (15) on
to the blowing aperture of the motor
housing (1) until it latches with the lo-
cking button (10).
3. Hook the carabiner (14) of the collec-
tion bag into the eyelets (19) provided
on the motor housing.
The additional handle (11) can be locked
in various positions.
1. Press the angle adjuster (17) on the ad-
ditional handle (11).
2. Adjust the additional handle to the desi-
red position.
3. Release the angle adjuster (17).
Putting on the carrying
strap
Never wear the carrying
strap diagonally across your
shoulders and chest: only
wear it on one shoulder to
ensure you can detach the
device quickly from your
body in the event of danger.
Pulling the push-fit lock (21) relea-
ses the device quickly from the
carrying strap. To open the push-fit
lock, press the two clamps together.
1. Place the carrying strap (13) on one
shoulder.
2. Adjust the strap length so that the snap
hook is approximately 10 cm below
your hip.
3. Attach the snap hook on the eyelet (12)
to insert the strap.

Operation

Caution! Risk of injury!
Always wear appropriate
protective equipment and
work gloves while working
with the device. Prior to each
use, ensure that the device
is working correctly. Ensu-
re that the device has been
mounted properly.
Stop using the device if the
On/Off button is damaged.
Personal protective equip-
ment and a fully functional
device reduce the risk of inju-
ries and accidents.
After the device has been
switched off, the impeller
continues moving for some
time. Injury hazard caused
by rotating tool!
Observe noise protection rules and
other local regulations.

Switching on and off

The cordless leaf vacuum/blower
may only be used with two batteries
of the Parkside X 20 V Team series.
Before switching the device on,
make sure that it is not touching any
objects. Ensure secure positioning.
GB IE
35