Herunterladen Inhalt Inhalt Diese Seite drucken

Installing Sanding Belts; Setting The Working Depth; Plunge Cutting; Pivot Handle - Parkside PSFS 250 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Kombi-fräser
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 43
Operation
Note: Please use suitable accessories available
from your speciality retailer to cut wall tiles.

Installing sanding belts

Install the sanding belts

Setting the working depth

(see Fig. E)
Loosen the wing bolt
Slide the base plate
depth (to cut through completely set approx.
3.2 mm deeper than the material thickness).
The recommended maximum cutting depth for
wood is 13 mm.
Retighten the wing bolt

Plunge cutting

Insert the bit into the work piece at an angle
of 45°.
Slowly straighten the bit to an angle of 90° to
begin the cut.
Note: The base plate
material surface.
Pivot handle (see Fig. F)
Pivot to horizontal
Press and hold the bevel stop
Turn the handle counter-clockwise
tical to horizontal until the bevel stop locks in.
40 GB/MT
Downloaded from
www.Manualslib.com
as shown in Figure C.
16
.
5
to the desired working
7
.
5
must be flush with the
7
7
.
13
manuals search engine
Pivot to vertical
Press and hold the bevel stop
Turn the handle clockwise
to vertical until the bevel stop locks in.
Using the rip fence (see Fig. G)
Loosen the wing bolts
and slide the guide bar for the circle- / rip
fence
15
tom of the base plate
facing down.
Position the tool the desired distance from the
edge of the work piece. Tighten the wing bolts
to secure the circle- / ripe fence
plate
7
Cutting circles (see Fig. H)
Note: the position of the guide hole depends on
the desired result, either inside or outside of the
edge of the circle: inside for holes, outside for
discs. The radius can be set from ca. 5 to 16 cm.
Make a circle on the work piece.
Mark the centre and drill a hole into the hole
(plunge cut).
Drill a guide hole on the edge of the circle
(plunge cut) (guide hole diameter 3 mm).
Loosen the wing bolts
and slide the guide rod for the circle- / rip
fence set
tom of the base plate
facing down.
Insert the centring tip in the middle of the circle.
Adjust the distance of the circle- / rip fence set
so as to plunge the bit into the guide hole at
the edge of the circle.
Lock the base plate
bolts
.
9
Press and hold the ON / OFF switch
power on the unit.
Slowly push the unit forward.
from ver-
.
13
from horizontal
on the base plate
9
through the two openings in the bot-
, with the rip fence
7
15
.
in the foot plate
9
through the two holes in the bot-
15
, with the centring tip
7
by tightening the wing
7
7
9
to the foot
7
15
to
4

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis