Stop/Start System; General Information; Operation; Engine Stopping Mode With Manual Gearbox - Fiat TIPO Handbuch

For example:
If the ORC (airbag) module is replaced during servicing, it needs to receive the airbag Proxy
information from the BCM in order to configure itself.
The BCM extracts the part relating to the airbag module from the Proxy and sends it to the latter in a
file.
The Proxy alignment must always be carried out after running "restore vehicle configuration".

STOP/START SYSTEM

General information

The STOP/START (S&S) device automatically stops the engine whenever the vehicle is stopped
and restarts it when the driver wants to start driving again.
This improves the efficiency of the vehicle by reducing fuel consumption, the emission of harmful
gases and noise pollution.
Manual activation and deactivation
The S&S device can be activated/deactivated using the S&S button on the dashboard, as shown in
the figure.
The deactivation of the system is indicated through a message on the instrument panel. When it is
deactivated, the button's LED is on. When the system is active, the LED is off.

Operation

Engine stopping mode with manual gearbox.

With the vehicle stationary, the engine (3) stops with the gearbox in neutral (1) and the clutch pedal (2)
released.
The engine can be stopped at speeds below 7 km/h.
All rights reserved. The circulation and reproduction of all or part of this guide by any means is prohibited.
FIAT TIPO -42- 0.0
REV