Welding Mask; Tig Welding - Parkside PMSG 200 A1 Montage-, Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

MMA welding / TIG welding
Attention: Do not dab on the
workpiece with the electrode. It could be
damaged and make it more difficult to
ignite the arc. As the soon as the arc is
ignited, try to maintain a distance to the
workpiece which corresponds to the
diameter of the electrode being used.
The gap should remain as constant as
possible while you are welding. The
inclination of the electrode in the
direction of operation should be
20–30 degrees.
Attention: Always use pliers to
remove used electrodes or hot work-
pieces. Make sure that the electrode
holder is always placed onto an insu-
lated surface after welding. The slag
can only be removed from the seam
once it has cooled down. To continue
welding an interrupted seam:
First remove the slag at the connec-
„
tion point.
The electric arc is ignited in the weld
„
groove, guided to the connection
point, melted properly there and then
continues from that point.
Attention: Welding generates heat.
Therefore the welding device must run
idle for at least half an hour after use.
Alternatively, you can leave the device
to cool for an hour. The device can only
be packed away and stored once the
temperature of the device is normal
again.
Attention: A voltage which is 10%
below the rated input voltage of the
welding device can have the following
consequences:
The power to the device will reduce.
„
The arc stops or becomes unstable.
„
82
GB/MT
Attention:
The arc radiation can lead to inflam-
„
mation of the eyes and skin burns.
Casting and welding slag can cause
„
eye injuries and burns.
Fit the welding mask as described
„
below in the section "Fit welding
mask".

Welding mask

HEALTH HAZARD!
If you do not use the welding mask,
harmful UV radiation and heat emitted
by the electric arc could damage your
eyes. Always use the welding mask for
welding work.
It is essential that you only use the
„
welding cable which is included
with the delivery (16 mm
between push and drag welding.
The following section shows the
impact of the direction of movement
on the properties of the weld seam:
Note: You decide for yourself which
type of welding is most suitable, once
you have welded a sample piece.
Note: Once it has worn down com-
pletely, the electrode must be replaced.
z TIG welding
For TIG welding please follow the
instructions for your TIG torch. You can
select TIG mode by pressing the welding
mode selector key
the "TIG" position.
). Choose
2
. To do this select
35