Hama 00176578 Bedienungsanleitung Seite 6

Example installation in wood / drywall ceiling:
1. Before commencing any installation,
maintenance or repair work, please disconnect
the power circuit by disconnecting the fuse.
2. Secure the power circuit against being
switched back on.
3. Check that the minimum installation depth of
80 mm (47 mm light + 33 mm clearance) is
available. The clearance between the upper
edge of the light and the ceiling must not
be less than 33 mm to allow ventilation. The
minimum distance between the lights and
ammable materials must be no less than
50 cm. Do not cover the light with any heat-
insulating material.
4. Mark out the position where the light is to
be installed.
5. Create an installation opening with a diameter
of 75 mm using a suitable hole saw. Take
care not to disturb any hidden installation or
supply lines.
6. The terminal points (e.g. terminal strip)
between the domestic installation and the
built-in spotlight connection cable must be
clamped in suitable junction boxes. (Not
included in the extent of delivery).
7. Continuing cables to the next built-in light
must correspond in terms of structure and
insulation to the operating mode. The yellow
/ green (earth / PE conductor) cable is not
connected. Other lights are cabled in parallel.
230 V
50 Hz
8. Close the junction box and push it into the
installation opening. Also ensure that the cables
are free of compressive and tensile forces.
Protect all cables and insulation from any
potential damage.
9. Position the built-in light at an angle and rst
insert a clamp into the installation opening.
The springs on the clamp are very powerful
and can cause injury if due attention is
not paid!
6
10. Now guide the second clamp into the
installation opening. The built-in light is
now slowly introduced all the way into the
installation opening. The force of the clamps is
su cient to hold the built-in light in position.
11. No further xings are needed. For precise
alignment, the built-in light can be easily
repositioned and rotated. The internal part of
the light can also be swivelled.
12. Only reinsert the fuse once all built-in lights
have been installed.
Removal
1. Pull the built-in light out of the installation
opening on one side. Take care to ensure that
the clamp does not accidentally slip out of
the opening. Otherwise there is a danger that
ngers may become trapped.
2. First carefully remove one clamp, then the
other, from the installation opening.
3. The further removal process is carried out in
the reverse order to the installation process.
5. Getting started
• Download the Hama Smart Solution app from
the Apple App Store or on Google Play.
• Open the Hama Smart Solution APP
• The rst time you use the app, you need to
register and create a new account. If you already
have an account, log in with your access details
• The LED built-in spotlight starts to ash quickly (if
it does not, switch the LED built-in spotlight ON
and OFF again quickly 3 times)
• Now click the + at the top right-hand corner and
select Lighting, then your device.
• Con rm that the LED built-in spotlight is ashing
quickly.
• Now enter the name of your WiFi network and
the password and con rm.
• The LED built-in spotlight is now connected. Once
the connection is successful, the LED built-in
spotlight will stop ashing
• You can now set up, control and con gure the
WiFi Smart LED built-in spotlight with the APP