ABB i-bus KNX Produkthandbuch Seite 38

®

i-bus KNX EG/A 32.2.1
Status_ Switching/Dimming Load
Status_ Illumination
Status_ Illumination Setpoint
Status_ Magnet Contact
Status_ Power Relay
Status_ Power Relay Timer
Status_ Repeater
Status_ Occupancy
Status_ Actual Setpoint
Status_ Alarm
Status_ Automatic/Override
Status_ Control Variable
Status_ Controller Mode On/Off
Status_ Controller Cool/Heat
Status_ Controller Mode
Temperatur
Status_ Fan Man/Auto
Status_ Fan Stage
Status_ Fan Stage Available
Status_ Normal /Hold-off Stop
Status_ Room Occupancy
Status_ Room Occupancy Frost
Status_ Room Occupancy Mode
ABB STOTZ-KONTAKT GmbH
Eppelheimer Straße 82, 69123 Heidelberg, Germany
 +49 (0) 6221 701 607  +49 (0) 6221 701 724
1 bit DPT_Bool
2 bytes DPT_Value_Lux
1 byte DPT_Scaling
1 bit DPT_OpenClose
1 bit DPT_Switch
1 bit DPT_Enable
1 bit DPT_Enable
1 bit DPT_Occupancy
2 bytes DPT_Value_Temp
1 bit DPT_Alarm
1 bit DPT_Bool
1 byte DPT_Scaling
1 bit DPT_Switch
1 bit DPT_Heat/Cool
1 byte DPT_ErrorClass_HVAC
1 bit DPT_Bool
1 byte DPT_Scaling
1 bit DPT_Bool
1 bit DPT_Bool
1 bit DPT_Occupancy
1 bit DPT_Bool
1 byte DPT_OccMode
1.002 R T 0 – Switching; 1 - Dimming
9.004 R T lux
5.001 R T %
1.009 R T 0 – Open; 1 – Close
1.001 R T 0 – Off; 1 - On
1.003 R T 0 – Disable; 1 – Enable
1.003 R T 0 – Disable; 1 – Enable
1.018 R T 0 – Not occupied; 1 – Occupied
9.001 R T ºC
1.005 R T 0 – No alarm; 1 - Alarm
1.002 R T 0 – Auto; 1 - Override
5.001 R T %
1.001 R T 0 – Off; 1 – On
1.100 R T 0 – Cooling; 1 – Heating
20.012 R T 1 – Heat; 3 – Cool; 6 - Off
1.002 R T 0 – Normal; 1 – Auto
5.001 R T %
1.002 R T 0 – False; 1 – True
1.002 R T 0 – Normal; 1 – Hold-off
1.018 R T 0 – Not occupied; 1 – Occupied
1.002 R T 0 – False; 1 – True
20.003 R T HVAC Control Mode
www.abb.com/knx
Technische Helpline / Technical Support
 +49 (0) 6221 701 434 E-Mail: knx.helpline@de.abb.com
Benutzerhandbuch r1.4 de
37 / 50