Chamfering Edges; Using The Rip Fence; Using The Fold Depth Stop (See Fig . G); Removing/Replacing The Planing Blade - Parkside PEH 30 C3 Betriebsanleitung

Chamfering edges

The V grooves in the front plane sole
easy chamfering of workpiece edges .
♦ Use the V groove that corresponds to the
chamfer width required .
♦ Place the planer with the V groove
workpiece edge and guide it forwards .

Using the rip fence

♦ To fit the rip fence, guide the connecting
screw through the connecting piece
8b
the rip fence .
♦ Place the washer
8c
screw .
8b
♦ Screw the lock nut
screw .
8b
♦ Fit the rip fence
the fastening screw
♦ Undo the lock nut
♦ Retighten the lock nut
♦ Ensure that the plane is applied with lateral
pressure .
Using the fold depth stop (see fig . G)
♦ Fit the fold depth stop
using the fastening screw
♦ Set the desired fold depth in millimetres using
the fold depth stop
♦ Repeat the planing process several times until
the required fold depth is achieved .
■ 8 │ GB │ IE │ NI │ CY
allow
onto the
8a
on the connecting
onto the connecting
onto the appliance using
.
and set the desired width .
.
onto the appliance
.
.
Removing/replacing the planing
blade (see figs . C–E)
WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance .
CAUTION!
► There is a risk of injury due to the cutting
edges of the planing blade
► Never touch the planing blade
and
cutting edges .
The planing blade
can be turned .
♦ Replace the planing blade
edges are blunt .
♦ Do not try to sharpen the planing blade
Turn the planing blade
WARNING! RISK OF INJURY!
► Wear suitable protective gloves when changing
the planing blades .
NOTE
► Do not undo the two hex socket screws .
These are used for adjusting the height of the
cutter block . No adjustment is required if you
use the planing blades sold by the manufac-
turer . Use only the planing knives supplied by
the manufacturer .
► When changing the blade, always replace
both blades to prevent an imbalance .
► Unscrew only one blade to start with . This will
allow you to use the factory-mounted second
blade for reference when reassembling later .
♦ Use the supplied open-ended spanner
undo the 3 fastening screws
that the planing blade
(see fig . C) .
♦ Push the movable cutter block guard
slot in the housing .
!
on its
has two cutting edges and
when both cutting
or replace it
a little way so
can be moved
into the
PEH 30 C3
.
to