Operation; Switching On And Off; Setting The Cut Depth; Dust/Chip Extraction (See Fig . A) - Parkside PEH 30 C3 Betriebsanleitung

Operation

Switching on and off

Switching on
♦ First, press the safety lock-out
♦ Then press and hold the ON/OFF switch
You can now release the safety lock-out
Switching off
♦ Release the ON/OFF switch
NOTE
► For safety reasons, the ON/OFF switch
cannot be locked .

Setting the cut depth

Use the dial to adjust the cutting depth
(0–3 mm) in 1/10 mm increments using the
cutting depth scale .
Dust/chip extraction (see fig . A)
WARNING!
Always wear a dust mask!
WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance .
Adjustable chip ejector (left/right)
♦ Unlock the chip ejector
opposite direction to the arrow (from the
"LOCK" position) .
♦ Pull the chip ejector
♦ The chip ejector
plane on the left or the right . Make sure that
the tab on the chip ejector
sponding recess on the housing .
♦ Push the chip ejector
♦ Lock the chip ejector
position "LOCK" .
PEH 30 C3
.
.
by turning it in the
out of the appliance .
can be attached to the
fits into the corre-
into the appliance .
by turning it to the
External extraction
When using dust extraction systems, e .g . a work-
shop extractor, it may be necessary to use the
adapter for external extraction
cleaner must be suitable for the material being
processed .
.
Connecting
.
♦ Push the adapter for external extraction
firmly into the chip ejector
♦ Push the hose of a suitable dust extraction
appliance (e .g . a workshop vacuum cleaner)
onto the chip ejector
external extraction
Removal
♦ Pull the hose of the vacuum cleaner off the chip
ejector
♦ Pull the adapter for external extraction

Parking shoe (see fig . B)

The parking shoe
appliance without risking damage to the work-
piece . While working, the parking shoe
flipped up and rear part of the plane sole
exposed .

Planing

CAUTION! RISK OF KICKBACK!
► Always switch the appliance on before
applying it to the workpiece .
♦ Set desired cut depth .
♦ Switch the appliance on .
♦ Place the appliance with the front part of the
plane sole
♦ Move the appliance with straight, even motions
over the workpiece .
♦ Push forward slowly and do not exert excessive
pressure on the plane sole
reduces the surface finish and can lead to a jam
in the chip ejector .
. The vacuum
.
(or the adapter for
, if required) .
or the adapter .
allows you to put down the
on the workpiece .
. Excessive speed
GB │ IE │ NI │ CY
off .
is
is
│ 7 ■