Parkside PDSS 310 B5 Originalbetriebsanleitung Seite 25

■ Switch off the tool when not in use .
■ Use personal protective equipment . Always
wear eye protection . Wearing protective equip-
ment such as a dust mask, non-slip safety shoes,
a helmet or hearing protection depending on
the type and use of the compressed air tool
reduces the risk of personal injuries .
■ Check all connections and supply lines . All
maintenance units, couplings and hoses must
correspond to the tool parameters in terms of
pressure and air flow . If the pressure is too low,
the function of the tool will be compromised
and if the pressure is too high, this can cause
property damage and personal injury .
■ Protect the hoses against kinking, constriction,
solvents and sharp edges . Keep hoses away
from heat, oil and rotating parts .
■ Ensure that the hose clamps are always tightened
firmly . Loose or damaged hose clamps can allow
air to escape in an uncontrolled manner .
■ Replace a damaged hose immediately . A de-
fective supply line can cause a compressed air
hose to thrash about and cause injuries .
■ If the power cable of this tool is damaged, it
must be replaced by the manufacturer or its
customer service department or by a similarly
qualified person in order to avoid hazards .
■ Do not use the tool if you are tired or under
the influence of drugs, alcohol or medication .
A moment of inattention when operating the
tool can result in serious injuries .
■ Do not inhale the exhaust air directly . Avoid
getting exhaust air in your eyes . The exhaust air
from the compressed air tool can contain water,
oil, metal particles or dirt from the compressor .
These can be hazardous to health .
WARNING!
► BE CAREFUL WHEN PUTTING DOWN THE
TOOL! Always put the tool down in such a
way that it does not lie on the trigger . Under
certain circumstances, this might cause an
accidental activation of the tool, which in turn
might lead to hazards .
PDSS 310 B5
■ Only suitable accessories may be used . These
can be purchased from the manufacturer .
Failure to use original accessories can result in
hazards .
■ Use only filtered and regulated compressed air .
Dust, corrosive vapours and/or moisture can
damage the motor of a compressed air tool .
■ The hose must be designed for min . 6 .3 bar or
125 psi, corresponding to at least 150% of the
maximum pressure generated in the system .
■ The tool and the supply hose must be fitted with
a hose coupling that allows the pressure to be
relieved completely when the coupling hose is
disconnected .
■ DANGER! Avoid contact with live cables .
This tool is not insulated against electric shock .
WARNING! RISK OF INJURY!
► At high working pressures, kickback forces
can occur . Under certain circumstances these
can cause hazards due to continuous loads .
■ If you are inexperienced with the tool, seek
training in how to use it safely .
WARNING! RISK OF INJURY!
► RISK OF PUNCTURE WOUNDS! Do not
treat an injection wound as a simple cut .
A high-pressure jet can inject toxins into the
body and cause serious injuries . In the event
of injection into the skin, seek medical assis-
tance immediately .
■ The compressed air tool must not be modified in
any way without the manufacturer's approval .
■ Use the compressed air tool only at the specified
pressure .
■ The compressed air tool must always be discon-
nected from the air supply after use and for as
long as it is not in use .
■ The compressed air tool must not be used if it is
not airtight or if it requires repair .
■ Never connect the compressed air tool using a
compressed air hose whose pressure exceeds
6 .3 bar .
GB │ IE │ 21 ■