Inserting/Changing The Battery - VOLTCRAFT VC271 TRMS Bedienungsanleitung

e) Inserting/changing the battery
The multimeter is powered by a 9 V block battery (e.g. 1604A). Insert a new, fully-charged battery before using the
multimeter for the first time or when the low battery symbol ( ) appears on the display.
Follow the steps below to insert/replace the battery:
- Disconnect the multimeter and test leads from all circuits, and then disconnect all test leads from the multimeter.
Switch off the multimeter.
- Remove the battery/fuse compartment cover (see "Opening the battery/fuse compartment").
- I nsert a new battery with the same specifications. Pay attention to the polarity markings in the battery compartment.
- Carefully replace the battery/fuse compartment cover.
Never use the multimeter when the battery/fuse compartment is open. !RISK OF FATAL INJURY!
Do not leave empty batteries in the device. Even leakproof batteries may corrode and destroy the
device or release chemicals that are detrimental to your health.
Do not leave batteries unattended, as they may be swallowed by children or pets. Seek immediate
medical attention if a battery is swallowed.
If you do not plan to use the multimeter for an extended period, remove the battery to prevent it
from leaking.
Leaking or damaged batteries may cause acid burns if they come into contact with your skin.
Always use protective gloves when handling leaking or damaged batteries.
Batteries must not be short-circuited or thrown into open flames!
Do not recharge or disassemble non-rechargeable batteries, as this may cause an explosion.
Use the following item number to order a compatible Alkaline battery:
Item no. 652509 (please order 1 battery).
Only use alkaline batteries, as alkaline batteries are more powerful and have a longer lifespan.
59