Parkside PMTS 180 A1 Originalbetriebsanleitung Seite 25

■ Always clamp the workpiece to be processed
firmly. Never use workpieces which are too
small to clamped firmly. The distance between
your hand and the rotating cutting disc is other-
wise too small.
■ If the cutting disc jams, switch the power tool
off and wait until the cutting disc has
completely stopped turning. Never attempt to
pull a rotating cutting disc out of a cut. This
could lead to a kickback. Identify and remove
the cause of the jam.
■ Do not apply lateral pressure to try and slow
the cutting disc down after switching off the
appliance. The cutting disc might be damaged,
break or cause a kickback.
■ Never ram the cutting disc into the workpiece
forcefully, and never apply too much force
when using a power tool. You should espe-
cially avoid jamming the cutting disc when
working on corners, sharp edges etc. If the
cutting disc is damaged by misuse, it can form
cracks that result in sudden breakage.
■ Wear a safety apron. Ensure that nobody
can be endangered by flying sparks. Remove
all flammable material from the vicinity.
Grinding metal creates flying sparks.
■ Only use the abrasive cutter for materials
specified in the instructions for proper use.
Otherwise, the abrasive cutter can be over-
loaded.
■ Never use any damaged, non-circular or
vibrating cutting discs. Damaged cutting discs
cause increased friction, jamming of the cutting
disc and kickback.
│ GB │ IE
■ 22
■ Always use cutting disks of the correct size
and with an appropriate central fixing bore
(e.g. diamond-shaped or circular). Cutting
disks which do not match the fitting parts on the
abrasive cutter will run eccentrically and cause
loss of control.
■
Do not use chains or toothed saw blades.
Such accessories often cause a kickback or loss
of control over the power tool.
■ Observe the operating manual published by
the cutting disc manufacturer when fitting and
using the cutting disc. Unsuitable cutting disks
can lead to personal injury and may cause
snagging, tearing of the disc or kickback.
■ Do not use any accessories that have not been
specifically provided or recommended by the
manufacturer for this power tool. Just because
you can attach the accessories to your power
tool does not guarantee they are safe to use.
■ Do not touch the cutting disks after work until
they have cooled down. Cutting discs become
very hot while they are working.
■ Check the cable regularly. Damaged cables
may only be repaired by an authorised
customer service location for power tools.
Replace any damaged extension cables. This
will ensure that the safety of the power tool is
maintained.
■ Store unused power tools safely. The storage
location must be dry and lockable. This
prevents the power tool being damaged by
storage or being used by inexperienced
persons.
■ Secure the workpiece! A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand.
■ Never leave the tool until it has come to a
complete standstill. Power tools which continue
to run on can cause injuries.
■ Do not use the power tool with a damaged
cable. Never touch a damaged cable and
remove the plug from the mains socket if the
cable becomes damaged during work.
Damaged cables increase the risk of electric
shock.
PMTS 180 A1