Further Safety Instructions For Abrasive Cutters - Parkside PMTS 180 A1 Originalbetriebsanleitung

c) Do not use a toothed, wood-cutting or chain
saw blade or segmented diamond-coated
disc with more than 10 mm wide gaps. Such
accessories often cause a kickback or loss of
control over the power tool.
d) Avoid cutting disc jams or excessive contact
pressure. Do not make any excessively deep
cuts. Overloading the cutting disc increases the
stress and likelihood of tilting or blocking and
thus the possibility of a setback or a breakage
of the grinding tool.
e) If the cutting disc jams or you stop working,
switch the tool off and hold the cutting appli-
ance steady until the disc has completely
stopped turning. Never attempt to pull a
rotating cutting disc out of a cut. This could
lead to a kickback. Identify and remove the
cause of the jam.
f) Do not switch the power tool back on for as
long as it is in the workpiece. Allow the
cutting disc to reach its full speed before you
carefully continue the cut. Otherwise, the disc
can jam, jump out of the workpiece or cause
kickback.
g) Support large workpieces to reduce the risk
of the cutting disc jamming and causing a
kickback. Large workpieces can bend under
their own weight. The workpiece must be
supported on both sides, namely in the vicinity
of the cut, and also at the edge.
PMTS 180 A1
Further safety instructions
for abrasive cutters
■ Never stand on an electrical appliance.
Serious injuries can occur if the electrical appli-
ance tips over or if you inadvertently come into
contact with the cutting disc.
■ Always use the protective cover. A protective
cover protects the user against parts of the
cutting disc which have broken off and also
against unintentional contact with the cutting
disc.
■
Ensure that the protective cover is working
properly and that it can move freely. Never
clamp the protective cover when it is in the open
position.
■ Use the appliance only for dry cutting.
Water entering a power tool will increase the
risk of electric shock.
■ Keep the power cable away from any
rotating accessories. The power cable can be
cut through or caught up.
■ Keep handles dry, clean and free from oil
and grease. Greasy, oily handles are slippery
and result in loss of control.
■
Never remove cutting leftovers, metal swarf
etc. from the cutting area while the power
tool is running. Always place the tool arm in
the idling position and switch the power tool off.
■ Always switch on the power tool before
applying it to the workpiece. Otherwise, there
is a danger of kickback if the cutting disc
becomes caught up in the workpiece.
■ Only use the power tool if the working surface
is free of all adjusting tools, metal swarf etc.
except for the workpiece to be processed.
Small pieces of metal or other objects which
come into contact with the rotating cutting disc
can hit the operator at high speed.
GB │ IE │
21 ■