ABB solar inverters
Quick Installation Guide
BATTERY PACK
EN
2.
BATTERY PACK
Battery type: AAA Ni-Mh Rch.
Voltage: 4 x 1,5 V
Capacity: 500 mA/h
Ta(°C): -20 to +55
V
DC: 18-48 V
IN
Ta(°C): -20 to +55
WARNING:
Replace batteries only
with the same type.
3.
Available Components
BATTERY PACK
Battery Pack
Battery type: AAA Ni-Mh Rch.
Voltage: 4 x 1,5 V
Capacity: 500 mA/h
Ta(°C): -20 to +55
WARNING:
Replace batteries only
with the same type.
Wire (200 mm) + connectors (assembled)
ABB
XXXX
solar
inverter
XXXX
s
XXXX
XXXX
XXXX
XXXX
XXXX
XXX
XXXX
XXX
Quick Installation Guide
In addition
technical
The
to what
documenta
is explained
and
tion
in this
interface
the
guide,
the
and
safety
and
manageme
installation
nt software
for the
informatio
n provided
product
are
available
in the
installation
website.
at the
manual
mus
t be
read
and
followed.
PVI-AEC-EVO
Power ON
A
Bus ON
Fault
B
1 2
Quantity
1.
The BATTERY PACK is an expansion module specifically designed for PVI-AEC-EVO which
provides a back-up for the PVI-AEC-EVO monitoring system.
The battery pack includes 4 x 1,2Vdc AAA type Ni-Mh rechargeable batteries: please refer to the
below table for the characteristic.
The PVI-AEC-EVO System is equipped with an integrated battery charger that can recharge the
batteries of the BATTERY PACK.
When the batteries are used for the first time, they may not be fully charged: to obtain a full char-
ge, the battery pack must be connected to the PVI-AEC-EVO (powered by 24Vdc source) for a
period of at least 24h.
The BATTERY PACK is able to supply the PVI-AEC-EVO in case of the 24Vdc failure but is not
able to turn on the PVI-AEC-EVO from the shut down condition.
When the system is powered by the battery pack, there are no limitation to the embedded functio-
nalities of the system: the presence of the battery pack provides full system operation in absence
of supply voltage 24Vdc.
The battery pack is able to keep the system up for a period of approximately 30 minutes, after
which the system will shut down completely.
In the event that the system PVI-AEC-EVO is equipped with the expansion module GSM / GPRS,
the absence of supply voltage 24Vdc, will be notified by sending an SMS alert containing "W004
- AC Failure".
Once the power supply is back, (power supply is back while the system is powered by the BAT-
TERY PACK) another SMS is sent, to alert about this event.
If the power supply is reconnected after a full battery discharge, the system will send an SMS
alerting about a system boot event (I005 - Wake Up).
4.
Battery Type
Battery Voltage
Battery Rated Capacity
Battery Charge Current
Max. Ambient Working Temperature
Min. Ambient Working Temperature
Operating Humidity
Protection Degree
Useful Life (see note)
NOTE: The batteries must be changed every 25.000 power on hours to assure a back-up
data during black-out.
CAUTION! RISK OF EXPLOSION IF BATTERIES ARE REPLACED BY A WRONG TYPE.
REPLACE BATTERIES ONLY WITH SAME MANUFACTURER PART NUMBER.
5.
Provision for recycling of exhausted batteries
For proper disposal of exhausted batteries, it is necessary be scrapped at an authorized col-
1
lection center, in compliance with European Directive 2002/96/EC (WEEE Directive) has been
acknowledged into the Italian law by Legislative Decree Nr. 151, dated July 25, 2005.
1
Contact us
www.abb.com/solarinverters
1
Technical Data
Panasonic Model HHR60AAAH
AAA Ni-Mh Rechargeable battery
www.panasonic.com
4 x 1.2 V
500 mAh
50 mA
+55 °C
-20 °C
25 to 95 % RH @ +40 °C
IP20
100.000 Hour
(@ 40 °C Ambient Temperature)
BCB.00047.2AP - BATTERY PACK - Quick Installation Guide REV.A
EFFECTIVE 2014-05-14
© Copyright 2014 ABB. All Rights Reserved.
Specifications subject to change without notice.