Parkside PDEME 130 A1 Bedienungs- Und Sicherheitshinweise Seite 56

Press MAX/MIN 5 again.
Shown in the display 3 (fig. E):
–MIN 12 and
–the lowest detected decibel reading
The decibel reading is updated in the display when an
even lower decibel reading is detected.
Press MAX/MIN 5 again to toggle to the decibel
level measurement mode. MAX/MIN 12 disappears
from the display 3 .
Holding (freezing) a measured value
While taking a measurement in an area in which you
cannot read the display 3 , press Hold 6 to hold the
measured value in the display.
in the display.
Press Hold 6 again to take another measurement.
HOLD
9 is shown
GB/IE 55