Sachs PSM69-48-002-01-22 Einbau- Und Montageanleitung Seite 35

Performance-Gewindefahrwerke
Performance Coilover Kits
Kit-Nr.: PSM69-48-002-01-22
Heinrich Eibach GmbH suspension components should not be installed by private individuals.
When suspension components are removed or installed, the vehicle should be elevated on a lift plat-
form. If for whatever reason the vehicle is raised with a jack, it is essential to secure it against rolling.
Please note the following when removing and installing components:

All damaged parts must be replaced.

Make sure to re-install all removed parts – if not replaced by new Heinrich Eibach GmbH
components – and check for proper installation at least two times.

Self locking nuts must only be used once and have to be replaced!
Following removal and installation, check and/or readjust the following:

Freedom of motion for the wheel/tire combination

Wheel and axle alignment values

Braking systems and the associated control systems
If these elements are not tested and adjusted, the system conditions can fail and lead to serious dam-
age.
Installing Eibach suspension components will change your vehicle's handling properties – so drive
slowly and carefully at first until you become accustomed to the new properties. To prevent damage
and injury, please note the following:

Do not overload your vehicle. Always comply with and never exceed the wheel loads specified by
the manufacturer.

Avoid unusual, aggressive driving maneuvers with excessive demands (racing events, etc.)

Comply with and do not exceed all legally specified speed limits.

Avoid driving on unpaved roads or off-road. In low-speed zones, slow down to accommodate
special features (speed bumps, etc.), taking into account your vehicle's lower ground clearance.
These Heinrich Eibach GmbH suspension parts are only for use in road-authorized vehicles that meet
all legal regulations. We advise explicitly against using them for any other purpose. Otherwise serious
material damage and personal injury may result.
Hinweis Nr. 1798000811
Instruction No. E694800201
Erstellt am: 26.03.2019
Date:
Seite 35 von 42
Page 35 of 42