Backflushing; Operation; Modes - Steinbach Classic 250N Active Balls+ Originalbetriebsanleitung

4. Check the filter system and the connections for leaks.
In the case of leaks, wrap extra Teflon tape
5. Backwash the system (see section "Backwashing").

Backflushing

Do not backwash when using Steinbach Filter Balls. If the filter throughput
decreases, we recommend washing the filter balls by hand. If necessary,
exchange the filter balls.
1. Switch the pump
2. Connect the backwash line (see section "Connecting the backwash line").
3. Press and hold down the valve lever
4. Set the valve lever to the "BACKWASH" position and release it.
5. Connect the pump's power plug to the power supply.
6. Backwash the system until clean water emerges from the backwash line (max. 2
minutes).
7. Switch the pump
8. Press and hold down the valve lever
9. Set the valve lever to the "RINSE" position and release it.
10. Connect the pump's power plug to the power supply.
11. Let the pump run for 20 to 30 seconds to remove any residue in the valve head.
12. Switch the pump
The backwashing is completed.

Operation

A damaged device or damaged accessories may cause injuries.
- Check the device and the accessories (see section "Testing").

Modes

To set the modes listed below, proceed as follows:
42
off by pulling the power plug.
3
off by pulling the power plug.
3
off by pulling the power plug.
3
CAUTION!
Risk of injury!
around the affected connections.
15
on the valve head
23
on the valve head
23
.
1
.
1