Charging Process - Parkside PSSSA 20-Li A1 Originalbetriebsanleitung

GB IE
to ensure that they do not play
with the equipment.
• Only use chargers belonging to
the Parkside X 20 V Team series
to recharge the battery. Risk of
fi re and explosion.
• Before each use, check the
charger, cable and plug and
have them repaired by quali-
fi ed professionals and only with
original parts. Do not use a de-
fective charger and do not open
it up yourself. This ensures that
the safety of the device is main-
tained.
• Connect the charger only to a
socket with an earth. Ensure
that the mains voltage matches
the specifi cations on the charger
rating plate. Risk of electric
shock.
• Disconnect the charger from the
mains before closing or open-
ing connection to the battery/
power tool/device.
• Keep the charger clean and
away from wet and rain. Do not
use the charger outdoors. Dirt
and the entry of water increase
the risk of electric shock.
• The charger may only be
used with the corresponding
rechargeable batteries of the
Parkside X 20 V Team series.
Charging other batteries can
lead to injuries and the risk of
fi re.
• Avoid mechanical damage to
the charger. This can result in
internal short circuits.
• Do not operate the charger on a
combustible surface (e.g. paper,
textiles). Risk of fi re due to heat-
ing during charging.
18
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fi ed person in order to prevent
hazards.
• Do not use the charger to
charge non-rechargeable bat-
teries. The device could become
damaged.

Charging Process

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charg-
er, check that the battery's
outer surface is clean and
dry.
There is a risk of injury due
to electric shock.
Switch off the device and remove
the battery before carrying out any
maintenance work.
• Charge the battery before the fi rst time
of use. Do not briefl y recharge the bat-
tery several times in a row.
• Only charge with the originally sup-
plied charger.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to