Turn the rotary knob 3 to Ω .
Connect the test probes 9 across the resistor
to be tested .
The reading is shown in the display 6 .
NOTE: When the input is not connected (i .e .
at open circuit): OL ("over range") is shown in
the display 6 .
Continuity test
Before measuring:
–Disconnect all power at the circuit to be tested .
–Discharge all capacitors .
Connect
–the black test probe 9 to COM 8 and
–the red test probe 9 to
Turn the rotary knob 3 to
Press SELECT 4 repeatedly until
shown in the display 6 .
Connect the test probes 9 across the circuit to
be tested .
Resistance < 30 Ω (approx .): The built-in
buzzer sounds .
Diode test
Connect
–the black test probe 9 to COM 8 and
–the red test probe 9 to
7 .
/
.
17 is
7 .
GB/IE
53