Cleaning, Maintenance And Ordering Of Spare Parts; Carbon Brushes; Disposal And Recycling - Parkside BMR 1400 Bedienungs- Und Sicherheitshinweise

Anleitung_BMR_1400_4258583:_
10. Cleaning, maintenance and
ordering of spare parts
Important.
Always pull out the mains power plug before
starting any cleaning work.
10.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
We recommend that you clean the device
immediately each time you have finished
using it.
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment.
Ensure that no water can seep into the
device.

10.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be
replaced by anyone but a qualified electrician.
10.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
10.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
For our latest prices and information please go
to www.isc-gmbh.info
29.01.2009 10:35 Uhr Seite 11

11. Disposal and recycling

The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is
raw material and can therefore be reused or
can be returned to the raw material system.
The unit and its accessories are made of
various types of material, such as metal and
plastic. Defective components must be
disposed of as special waste. Ask your dealer
or your local council.
To comply with European Directive
2002/96/EC concerning old electric and
electronic equipment and its
implementation in national laws, old electric
tools have to be separated from other waste
and disposed of in an environment-friendly
fashion, e.g. by taking to a recycling depot.
Recycling alternative to the demand to return
electrical devices:
As an alternative to returning the electrical
device, the owner is obliged to cooperate in
ensuring that the device is properly recycled if
ownership is relinquished. This can also be
done by handing over the used
device to a returns center, which will dispose of
it in accordance with national commercial and
industrial waste management legislation. This
does not apply to the accessories and auxiliary
equipment without any electrical components
which are included with the used device.
For EU countries only
Never place any electric tools in
your household refuse.
GB
11