Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - Parkside BMH 1100 Bedienungs- Und Sicherheitshinweise

Anleitung_BMH_1100_4258396:_
GB/
MT
8.5 Clockwise/Counter-clockwise switch
(Fig. 9/Item 7)
Change switch position only when the
drill is at a standstill!
Switch the direction of the hammer drill
using the clockwise/counter-clockwise
switch (7):
Direction
Clockwise
(forwards and drill)
Counter-clockwise
(reverse)
8.6 Drill / Hammer drill / Chisel selector
switch (Fig. 10)
For drilling, press the button (E) on the
selector switch (5) and simultaneously turn
the selector switch (5) to position A.
For hammer drilling, press the button (E) on
the selector switch (5) and simultaneously
turn the selector switch (5) to position B.
For chiseling, press the button (E) on the
selector switch (5) and simultaneously turn
the selector switch (5) to position C. In
switch position C the chisel is not locked.
For chiseling, press the button (E) on the
selector switch (5) and simultaneously turn
the selector switch (5) to position D. The
chisel is locked in position D.
Important.
You only require slight contact pressure for
hammer drilling. Excessive contact pressure
will place an unnecessary strain on the motor.
Check bitsl at regular intervals. Sharpen or
replace blunt bits.

9. Replacing the power cable

If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer or its after-sales service or
similarly trained personnel to avoid danger.
38
21.11.2008 7:27 Uhr
10. Cleaning, maintenance and
Important.
Always pull out the mains power plug before
starting any cleaning work.
10.1 Cleaning
Switch position
Pushed in to the right
Pushed in to the left
10.2 Carbon brushes
In case of excessive sparking or if the status
indicator for carbon brush wear (12) lights up,
have the carbon brushes checked by a qualified
electrician.
10.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
10.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
For our latest prices and information please go
to www.isc-gmbh.info
Seite 38
ordering of spare parts
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
We recommend that you clean the device
immediately each time you have finished
using it.
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment.
Ensure that no water can seep into the
device.
Type of machine
Article number of the machine
Identification number of the machine