Herunterladen Inhalt Inhalt Diese Seite drucken

Preparing For Use; Connecting The Vacuum Sawdust Extraction Device; Changing A Saw Blade; Installing And Setting The Riving Knife - Parkside PHKS 1450 LASER Bedienungs- Und Sicherheitshinweise

Handkreissäge
Vorschau ausblenden Andere Handbücher für PHKS 1450 LASER:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 89

Preparing for use

Acrylic glass panels, Plexiglas
Aluminium board
Aluminium profiles
Plasterboard
Mineral wool board
Cement-bound chipboard
The circumferential speeds at minimum and
maximum rotational speeds are approx.:
Setting 1
1,800 rpm
Setting 6
5,000 rpm
Make sure that the cutting speed resulting from the
effects of different saw blades, materials and the
force you apply to advance the saw is always less
than the circumferential speed (CS) under no load.
Connecting the vacuum
Q
sawdust extraction device
j
Insert the adapter for vacuum sawdust removal
into the sawdust removal connector.
24
j
Connect a vacuum device approved for the
extraction of sawdust and splinters.

Changing a saw blade

Q
m Attention! Press the spindle lock only after
the mains plug has been pulled out of the socket!
1. Then remove the guide fence
the wing screw
10
2. Set the cutting depth (by means of the wing
screw for cutting depth setting clamp
the minimum position, 0 mm.
3. Swing back the automatic blade guard
and place the device down.
4. Press the spindle lock button (until it engages)
and release the clamping screw
the Allen key. Now remove the clamping
screw with integral washer head
clamping flange
20
5. Detach the saw blade.
6. The installation of a sawblade is done in the
14 GB
2-4
4-6
4-6
1-2
1-2
1-2
CS
20 metres/sec
CS
55 metres/sec
by releasing
12
.
) to
5
6
using
21
and the
21
(see Fig. D).
reverse order.
7. Press the spindle lock button
engages) and tighten the clamping screw
using the Allen key.
m Attention! The arrow on the saw blade must
agree with the arrow showing the direction of
rotation (running direction shown on the device).
j
Ensure that the saw blade is suitable for the
saw spindle speed.
Installing and setting the
Q
riving knife
m Attention! The distance between the riving
knife
and the saw blade must not be greater
16
than 5 mm. If the riving knife has been removed
e.g. for a plunge cut, this distance must be
observed again when the riving knife is reinstalled
(see Fig. F).
Removing the riving knife: (see Fig. E)
1. Release the wing screws of the cutting depth
setting clamp
and swing the circular saw
5
up until it meets the stop; this exposes the riving
knife mounting
.
22
2. Screw out the mounting screws
the riving knife
.
16
m Attention! After completion of the plunge
cut the riving knife
before the circular saw is used for any other
sawing tasks.
Setting the riving knife: (see Fig. F)
Set the distance between the riving knife
the tips of the saw blade teeth to a maximum of 5
mm, and the distance between the tip of the riving
blade and the lowest point of the saw blade to a
maximum of 5 mm.
The distances to be set are illustrated in Fig. F.
(until it
3
21
and remove
23
must be reinstalled
16
and
16

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis