Parkside PAH 1700 C3 Originalbetriebsanleitung Seite 31

˜ Troubleshooting
Problem Possible
cause
Chisel holder
Chisel 12 13
11 does not
falls out .
lock .
Product does No mains
not work . power .
Worn-out
carbon
brushes 16 .
Motor
defective .
Poor
Blunt chisel 12
performance .
13 .
Excessive
pressure on
the product .
Stroke rate set
too low .
Grease used
up .
30 GB/IE
˜ Disposal
The packaging is made entirely of recyclable
Solution
materials, which you may dispose of at local
recycling facilities .
Reinsert the
chisel 12 into
the chisel
holder 11 (see
"Inserting/
removing the
chisel") .
Check power
cord and
power plug
5 . Have
the product
repaired by
a qualified
specialist .
Have the
carbon brushes
16 replaced
by a qualified
specialist .
Have the
product
repaired by
a qualified
specialist .
Use new chisel
12 .
Apply
appropriate
pressure .
Increase stroke
rate (see
"Selecting the
stroke rate") .
Add grease 14
(see "Main-
tenance") .
Observe the marking of the packaging
materials for waste separation, which
are marked with abbreviations (a) and
numbers (b) with following meaning:
1 – 7: plastics / 20 – 22: paper and
fibreboard / 80 – 98: composite
materials
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment .
The Triman logo is valid in France only .
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product .
To help protect the environment, please
dispose of the product properly when
it has reached the end of its useful
life and not in the household waste .
Information on collection points and
their opening hours can be obtained
from your local authority .