Working Method; Introduction - Husqvarna AUTOMOWER 105 Bedienungsanweisung

1.5 Working method

®
Automower 315X/430X/450X use GPS-assisted
navigation to start mowing in a place in the yard where it
has not been lately. For the other models you might
have to set remote start settings to make sure that the
lawn is cut evenly, refer to the complete Operator's
Manual on Husqvarna's website.
When the product hits an obstacle or approaches the
boundary wire the product reverses and selects a new
direction. Sensors at the front and back will sense when
the product is approaching the boundary wire. The front
always passes the boundary wire by a specific distance
before the product turns around. The distance can be
changed to adapt to the installation if required.
The STOP button on the top of the product is mainly
used to stop the product when it's running. When the
STOP button is pushed a hatch opens, behind which
there is a control panel. The STOP button remains
pushed in until the hatch is closed again. This together
with the START button acts as a start inhibitor.
1418 - 007 - 17.09.2020
Note:
Always push the START button before closing
the hatch to start the product. If the START button is not
pushed, a message beep is heard and the product will
not start.
Note:
When the product is started for the first time, a
start-up sequence begins which includes a number of
important basic settings, refer to
in the complete Operator's Manual on Husqvarna's
website.
1.6 Finding the charging station
®
The Automower 305/310/315/315X/420/430X/
440/450X can be set to search for the charging station in
up to 3 different ways. The product automatically
combines these 3 search methods to locate the charging
station as fast as possible, but also to avoid as much
tracks forming as possible. Automower
follows the guide wire to the charging station.
To do the basic settings
®
105 always

Introduction - 3