Mounting The Drip Tray; Connecting The Milk System - Beko CEG7425B Bedienungsanleitung

Setting up
4
• The socket must be secured at
least 10A fuse breaker. Ensure
that the connecting cable is
undamaged and is not laid over
hot surfaces or sharp edges.
• Connection the mains supply
via an extension cable must not
exceed a length of 3 metres and
a cable cross-section of 1.5 mm².
For fire prevention reasons,
the use of multiple adapters or
power outlet strips is forbidden.
• The connecting cable must not
be pulled tight.
• The electrical safety of the
coffee machine is only assured
when it is connected to a properly
installed protective earth (PE)
conductor system. Connection
to a mains socket without PE
conductor is forbidden. If in
doubt, the electrical system
must be checked by a qualified
electrician. The manufacturer
assumes no liability for injury
or damage caused by a missing
or interrupted protective earth
conductor.
Fully Automatic Coffee Maker / User Manual
4.3 Mounting the
drip tray
Position the drip tray with the
stainless steel grid (8) centrally in
front of the appliance. Then push
it gently forwards against the bowl
until it engages in the operating
position.
4.4 Connecting the
milk system
The milk system must be connected
in order to dispense coffee
specialities with milk/frothed milk.
Proceed as follows:
1. Open the door with the coffee
outlet unit by pulling it up on the
left side.
19 / 233 EN