Changing The Engraving Tip; Working Procedures - Parkside PAGG 4 A1 Originalbetriebsanleitung

Changing the engraving tip

CAUTION! RISK OF INJURY!
► Always switch the appliance off before carrying out any work
on it.
♦ Change the engraving tip
longer delivers the desired engraving results. Turn the engraving
tip lock anticlockwise (in the working direction) until the
engraving tip lock
engraving tip
♦ Remove the spring and the washer.
♦ Slide the washer and spring onto a new engraving tip .
Then insert them and turn the engraving tip lock
(in working direction) to lock the tip in place.
♦ Ensure that the engraving tip

Working procedures

You can use the appliance to create imaginative and unique engrav-
ings. For example, you can permanently mark valuable items. You
can engrave numbers and letters onto metal, glass, wood, plastic,
ceramics, stone and leather. To do this, use the supplied engraving
templates .
♦ Hold the appliance at an angle, in the same way you would hold
a pen.
♦ Your arm should be resting on the table.
♦ Move the engraving tip
gentle pressure. To ascertain the ideal engraving speed, practice
on a spare piece of material.
│ GB │ MT
■ 62
as soon as it becomes worn and no
can be removed. From below, remove the
from the engraving tip lock .
is fixed correctly in place.
over the workpiece while applying
clockwise
PAGG 4 A1