Vibrations; Before Use; Setting Up The Appliance (See Fig. A); Mixing Fuel - Parkside PBLG 52 A1 Originalbetriebsanleitung

Vibrations

WARNING!
► You can reduce the vibration risk, for example, the risk of Raynaud's
phenomenon (circulatory problems), by taking regular breaks during
which you rub your hands together.
■ Always wear protective gloves and ensure your hands are warm.
■ Take regular work breaks.

Before use

Setting up the appliance (see fig. A)
♦ Take the two hose clips +
flexible pipe .
♦ Push the larger end of the flexible pipe
tighten the hose clip using the flat-head screwdriver
♦ Slide the control pipe into the flexible pipe section
the hose clip using the flat-head screwdriver .
♦ First loosen the fixing screws
♦ Slide the operating lever
♦ Attach the operating lever
and locking nuts .
♦ Push the pipe extension onto the control pipe
To fix the pipe extension
secure it by tightening the inserted screw.
If an extension is required, push the second pipe extension
previously mounted pipe extension
To fix the pipe extension
secure it by tightening the inserted screw.
♦ Push the desired end pipe (round)
pipe extension or and fix it in place by turning it clockwise
(see Fig. A) and secure it by tightening the inserted screw.
NOTE
► Higher air velocity = flat tailpipe
► Normal air velocity = circular tailpipe
Disassembly is carried out in the reverse order.
│ GB │ IE
■ 18
and slide them over the ends of the
onto the curved pipe
.
and tighten
on the operating lever .
onto the guide of the head pipe
using the supplied fastening screws
.
in place, turn it clockwise (see fig. A) and
.
in place, turn it clockwise (see fig. A) and
or end pipe (flat) onto the

Mixing fuel

The engine must be operated with a mixture of petrol and motor oil.
WARNING!
► Avoid direct skin contact with fuel and do not inhale fuel vapours.
■ Always use a mixture of unleaded petrol (at least RON 95) and special
2-stroke engine oil (JASO FD/ISO-L-EGD). Mix up the fuel mix
according to thefuel mix table.
■ Pour the correct amount of petrol and 2-stroke oil into the openings
provided in the enclosed mixing container
and
■ Tilt the mixing container
the chamber with the petrol.
■ Then give the mixing tank
.
Fuel mix table
Mixing process: 40 parts petrol to 1 part oil
Petrol
0.5 litres

Adding fuel

onto the
WARNING!
► Fill the fuel tank only when the engine is switched off and cooled
down. There is a risk of fire!
♦ Always clean the area around the fuel tank cap
prevent dirt getting into the fuel tank .
Use a dry, lint-free cloth to do this.
♦ Place the appliance on a suitable, level surface so that the fuel tank
cap is facing upwards.
♦ Turn the fuel tank cap
The fuel tank cap
device and cannot fall down.
♦ Fill the fuel tank
the fuel tank
♦ Wipe up any spilled fuel immediately.
♦ Turn the fuel tank cap
(see "Fuel mix table").
to the side so that the filled oil can flow into
a good shake.
2-stroke oil
12.5 ml
anticlockwise and remove it.
is connected to the fuel tank with an anti-loss
with the fuel mix. Do not spill any fuel while filling
and do not fill it to overflowing.
clockwise to close it.
before filling to
PBLG 52 A1