Cleaning And Care - Electrolux AFP880 Gebrauchsanweisung

822_949_311 AFP850-880_EX.book Seite 64 Dienstag, 22. Januar 2008 8:57 20
g
Citrus press
Preparation (fig. 13)
0 Fit all-purpose bowl as described above
(fig. 5).
0 Place sieve insert of citrus press (fig.
13/a) on all-purpose bowl (arrow
on arrow ) and turn cunter-clock-
wise to the stop. The sieve insert can
be heard to engage, arrow
coincide with arrow
0 Insert press cone (fig. 13/b) in sieve
insert.
Operating citrus press
0 Start appliance: turn speed selector
(fig. 1/I) right to position 1.
3 The citrus press must only be operated
at the lowest speed.
0 Switch off appliance: turn speed selec-
tor left to the "0" position.
0 Remove press cone after use.
0 Turn sieve insert clockwise and remove.
0 Turn all-purpose bowl clockwise and
remove.
The appliance can be used for up to
1
10 minutes without stopping. It should
be allowed to cool each time following
prolonged, continuous operation (for
at least 20 minutes after using for
10 minutes without stopping).

Cleaning and care

Motor casing
1 Ensure that no liquid enters the motor
casing!
0 Clean the motor casing with a moist
cloth. Never immerse in water or hold
under running water!
64
Mixer
Container and blade can be cleaned
3
easily and properly with the aid of the
pulse position.
0 Fill the mix container half full with
warm (not hot!) water and add a few
drops of detergent.
0 Press the pulse button briefly.
0 Then rinse the container under running
water.
must
.
Dismantle/fit blade unit (fig. 14)
If necessary, the blade unit can also be
3
dismantled and cleaned separately.
Caution: The blade is very sharp!
1
Danger of injury!
0 Release blade unit (fig. 14/a) from mix
container using the closing cover
(fig. 1/D and fig. 14/c) as tool. The
grooves of the closing cover fit the ribs
of the blade unit. Turn counter-clock-
wise and remove while holding slightly
at an angle.
0 Remove gasket (fig. 14/b) from blade
unit.
The blade unit is very sharp. The gasket
1
can be damaged.
1 Rinse the components carefully by
hand (danger of injury!). Use only
water and detergent for cleaning.
Do not clean the blade unit in a dish-
washer.
0 Insert gasket in blade unit.
0 Insert blade unit in container from
below. Hold blade unit at a slight angle.
Tighten blade unit using the closing
cover as tool by turning clockwise
(fig. 14).
All-purpose bowl and tools
0 The all-purpose bowl and tools should
be cleaned in rinsing water.
Caution: The metal blade is extremely
1
sharp! Danger of injury!