Initial Setup; Power On & Initial Setup; Playback - Pioneer N-30AE Bedienungsanleitung

> Before Start > Part Names
Power On & Initial Setup

Initial Setup

1
3
10
> Install > Initial Setup
2
> Playback
Starting up: When you press Í STANDBY/ON, the power
indicator on the main unit slowly blinks blue, then "Hello" is
displayed on the display about 20 seconds later. After this,
the display goes blank, then after the Pioneer logo is
BLUE BLINKING
displayed, you can start operating the unit.
Wi-Fi connection settings
When you first turn the power on, the initial setup screen is
displayed automatically, allowing you to easily make Wi-Fi
connection settings.
To set, select the item with the cursors on the remote
controller and press ENTER to confirm. To return to the
previous display, press RETURN.
To make Wi-Fi settings, select "Wi-Fi". If you have
connected with an ethernet cable, select "Wired(Exit)" and
confirm. If you select "Wi-Fi", select the method for setting in
the next screen (for example "Scan Networks").
Supplementary information | Advanced Setup | Others
Initial Setup
Selects the method of network
connection
Wi-Fi
Wired (Exit)
E
N