Functional Description - Makita DFJ305ZXL-P Betriebsanleitung

FUNCTIONAL
DESCRIPTION
NOTICE:
The fan jacket is effective when the
humidity and temperature of intake air are lower
than those of the body surface. The fan jacket
may not be effective if the air temperature and/or
humidity are higher than those inside the jacket.
Power button
To turn on the jacket, press and hold the power button on the
battery holder (optional accessory). The jacket starts at high
air speed. Each time you tap the power button, the air speed
changes from high to medium, medium to low, and low to
high. The air speed indicator shows the current air speed.
► Fig.12: 1. Air speed indicator 2. Power button
To turn off, press and hold the power button again.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
► Fig.13: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for few seconds.
Indicator lamps
Lighted Off
(For 14.4 V and 18 V batteries only)
(For 14.4 V and 18 V batteries only)
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Battery protection system
The device is equipped with a battery protection sys-
tem. This system automatically cuts off power to the
motor to extend battery life.
If the remaining battery capacity is too low, the device
will not operate. When you turn the device on, the motor
will run again, but stops soon. In this situation, remove
and recharge the battery cartridge.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Turbo button
By pressing turbo button on the battery holder, the jacket
works in turbo mode for quick cooling. Turbo mode lasts for a
minute and then air speed returns to normal.
► Fig.14: 1. Turbo button
Air flow
To maintain a stable air flow, close the button at the neck of the jacket.
Fasten the button on the ribbon for better air flow in the back.
► Fig.15: 1. Ribbon
Air flow inside the jacket is shown below.
► Fig.16
For a jacket with a hood, wear the hood over a helmet.
The air from the fan goes through the helmet and cools
your head.
► Fig.17
Battery pocket
A pocket is provided for storing the 10.8 V / 10.8 V - 12
V max battery holder (with battery) inside the jacket.
Connect the power cable to the battery holder, and then
put it into the pocket and fasten the snap buttons.
► Fig.18
Mesh pocket
Mesh pockets are provided on the back of the jacket for
storing ice packs.
► Fig.19: 1. Mesh pocket
Connecting USB devices
CAUTION:
Connect only devices that are
compatible with the USB power supply port. Not
doing so may cause a malfunction of the battery
holder.
NOTICE:
Before connecting a USB device to
the battery holder (with the battery), always back
up the data on the USB device. Not doing so may
cause a loss of your data.
The battery holder (with the battery) can work as an
external power supply for USB devices.
Open the cover and connect a USB cable (not included)
to the power supply port of the battery holder. Then con-
nect the other end of the cable to the device and turn on
the switch next to the USB port.
► Fig.20: 1. Cover 2. Switch
The battery holder (with the battery) supplies DC5V,
2.1A. The USB cable can be placed inside the jacket for
convenience using the hole in the pocket and the cable
holder.
10 ENGLISH