Dell PowerVault MD3600f Handbuch Zum Einstieg Mit Dem System Seite 13

3 Insert the cable into an SFP module that is installed in the storage array.
4 Remove the two protective caps from the other end of the cable and store
5 Connect this end of the cable to one of the following devices:
To remove an FC cable:
1 Press and hold the lever to release the latches before removing the cable
2 On the end of the cable that connects into the SFP module or HBA,
3 While pressing down the cable lever, pull the connector to remove the
4 Replace the protective caps on the cable ends.
5 Replace the protective cap on the SFP module.
Downloaded from www.Manualslib.com
The cable connector is keyed for correct installation. Holding the
connector, push in the cable until it clicks into place.
them future use.
– An SFP module that is installed in an FC switch port
– A FC HBA port
from the SFP module. Ensure that the levers are in the released position
when removing the cable. Do not grasp the SFP module plastic tab when
removing the cable.
press down and hold the lever to release the latches.
cable from the SFP module.
manuals search engine
Getting Started With Your System
11