Layout; Proper Use; Assembling The Welding Screen - Parkside KDM-2000 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

3. Layout

k Safety glass frame
l Welding glass
m Safety glass
n Safety glass retaining bushes
o Nuts for handle
p Screws for handle
q Safety glass retaining pins
r Handle
s Welding screen frame

4. Proper use

The welding screen is allowed to be used only
in combination with welder safety windows and
front auxiliary windows which are marked accor-
dingly, and only for welding purposes.
Important:
The welding screen is not designed for laser wel-
ding.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufac-
turer will be liable for any damage or injuries of
any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Anl_1549053_Schirm.indb 7 Anl_1549053_Schirm.indb 7
GB
5. Assembling the welding
screen
(Fig. 3-9)
•
Place the welding glass (l) and the transparent
safety glass (m) over it in the frame for the
safety glass (k) (Fig. 3).
•
Press the safety glass retaining pins (q) into
the holes in welding screen frame (s) from the
outside. (Fig. 4)
•
Place the frame for the safety glass (k) with
the welding glass (l) and transparent safety
glass (m) from the inside into the recess in the
welding frame (s), press the safety glass retai-
ning bushes (n) onto the safety glass retaining
pins (q) until they engage to secure the frame
for the safety glass (k). The transparent safety
glass (m) must be on the outside. (Fig. 5)
•
Bend the top of the welding screen frame (s)
inwards (Fig. 6/1) and fold down the top
corners (Fig. 6/2). Now bend the outer sides
of the welding screen frame (s) inwards (Fig.
6/3) and connect them by pressing the top
corners and outer sides together. When the
retaining pins engage, you should be able to
hear 2 clear clicks on each side (Fig. 6/4).
•
When the top corners of the welding screen
are connected as shown in Figure 7, place
the screws for the handle (p) from the outside
through the three holes in the welding screen.
(Fig. 8)
•
Turn over the welding screen and place the
handle (r) over the threads on the three screws
for the handle (p). Secure the handle (r) to
the welding screen using the three nuts for the
handle (o). (Fig. 9)
Marking on the product:
Einhell Germany AG CE EN 175 S
Einhell Germany AG = Manufacturer; CE = De-
claration of conformity; EN 175 = European stan-
dard; S = Increased strength
Important:
The screen is allowed to be used only in combi-
nation with welder safety windows and auxiliary
windows which comply with EN 166/169 and
- 7 -
18.10.12 12:24 18.10.12 12:24