Cleaning And Care - Klarstein Ice Volcano 2G Bedienungsanleitung

Problem
There are ice-cube inside
the unit, but can't dispense
the ice-cube when you
push the "ICE" button.
Ice making cycle is normal
but no ice is made.

CLEANING AND CARE

Before using your ice maker, it is strongly recommended to clean it thoroughly. Unplug
the unit before cleaning or making any maintenance.
1. Take out the accessory parts under top window.
2. Clean the interior with diluted detergent, warm water and a soft cloth. First pour the
warm water with diluted detergent into the internal water reservoir and the space
below the transparent window, then use the soft cloth to wipe the surface.
3. Again use the water to rinse the inside parts, and drain out the water by unplugging
the drain cap on the bottom.
4. The outside of the ice maker should be cleaned regularly with a mild detergent
solution and warm water.
5. Dry the interior and exterior with a soft cloth.
6. When the machine is not in use for a long time, open water drain cap to drain out
water completely from water reservoir.
Possible Cause
Moving shaft for the Ice-
cube is blocked.
Ambient temperature or
water temperature in inner
tank is too high.
Refrigerant liquid leakage.
Pipe in the cooling system
is blocked.
Solution
Release the button for
ice-cube for 3 seconds,
then again push the "ICE"
button.
Please run the ice maker
below 32 and pour
colder water into tank.
Verify by a qualified
technician.
Verify by a qualified
technician.
EN
25