Troubleshooting - Parkside PBM 125 A1 Originalbetriebsanleitung

GB IE

Troubleshooting

Problem Possible cause
Not enough petrol in the petrol
tank
Incorrect starting sequence
Engine won't
Spark plug connector (
start
not plugged in correctly, sooty
spark plug
Carburettor set incorrectly
Engine starts,
Dirty air filter (
but the device
does not run at
Carburettor set incorrectly
full power
Carburettor set incorrectly
Engine sput-
ters, slows
down
Sooty spark plug (
Ventilation holes (
Engine overhe-
Incorrect spark plug (
ated
Not enough engine oil in the
engine
Dirty air filter (
Engine giving
off smoke
Not enough engine oil in the
engine
Grass too short or high
Output not
satisfactory or Blade blunt
engine is diffi-
Blade blocked by grass, grass
collection box full, ejector
cult to operate
opening plugged
Blade blocked by grass
Blade not ro-
tating
Blade not mounted correctly
Abnormal
Blade not mounted correctly
sounds, clatte-
ring or vibra-
Blade damaged
tions
44
Troubleshooting
Fill petrol
Observe the instructions for starting
the engine (see "Operation")
12) Plug in the spark plug connector
Clean, set or replace spark plug (see
"Cleaning and Servicing")
Have the carburettor reset by a speci-
alist workshop
Replace the air filter (see "Cleaning
11)
and Servicing")
Have a specialist workshop reset the
carburettor
Have a specialist workshop reset the
carburettor
Clean, set or replace spark plugs (see
13)
"Cleaning and Servicing")
8) plugged Clean the ventilation holes
13) Replace the spark plug
Top up engine oil (see "Initial start-up")
Replace the air filter (see "Cleaning
11)
and Servicing")
Top up engine oil (see "Initial start-up")
Change the cutting height
(see "Setting the cutting height")
see „Replacing blades"
Remove grass (see "Cleaning and
Servicing")
Remove grass
Fit the blade correctly (see "Replacing
blades")
see „Replacing blades"