Operation; Disposal And Recycling; Cleaning, Maintenance And Ordering Spare Parts - EINHELL TE-CB 18/180 Li Solo Originalbetriebsanleitung

5.4 Battery capacity indicator (Fig. 4 /Item C)
Press the button for the battery capacity indicator
(B). The battery capacity indicator (C) will indicate
the charge status of the battery by means of 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs blink:
The battery pack has undergone exhaustive di-
scharge and is defective. Do not use or charge a
defective battery pack.

6. Operation

6.1 On/Off switch (Fig. 1/Item 2)
Switching on:
To switch on, press and hold the On/Off switch
(2).
Switching off :
Release the ON/OFF switch (2)
6.2 Speed control (Fig. 1)
The equipment has two speed settings. To select
a speed, push the selector switch (4) into the
desired position (1 or 2).
Note:
Activate the selector switch (4) only when the
equipment is at a standstill.
7. Cleaning, maintenance and
ordering spare parts
Hazard!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
Anl_TE_CB_18_180_Li_Solo_SPK9.indb 18 Anl_TE_CB_18_180_Li_Solo_SPK9.indb 18
GB
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 18 -
Autogoods "130"
12.12.2017 16:53:44 12.12.2017 16:53:44