Installation; Function Selection - Svs Sh-12 Rp Bedienungsanleitung

5

Installation

For the location of the repeater, select a place which is not shielded by conducting objects and position the antenna in such a way that
it is not subject to interference from the rest of the circuit. The helical antenna should not be positioned over or too close to the
electronics.
Before installing the repeater, please test and verify the function at the desired location. The location may have to be changed for
optimum operation.
Supply voltage: Connect the supply voltage to the input 5,0...16,0V DC.
Take care of the technical data and of the supply polarity. Maximum supply voltage is 16V DC. Greater supply voltage
destroys the transmitter.

Function selection

The 6 pole DIP switch gives the user the possibility to configure the repeater. In rare cases it is necessary to change the frequency
because of interference from other devices. In this case set the DIP switch #1 to position "ON" in order to switch to the second
frequency (f2 ). Please note that the corresponding radio devices should have the same frequency (see the corresponding device
instructions). The following table provides an overview of the effects of the indivdual DIP switch configurations.
DIP switch nr. Description
1 Frequency selection f1 = 433,62 MHz
2 Learn mode
3 Repeater mode
4 Traffic Control
5 LCC mode
6 n.a.
Learn and erase tranmitters
When the DIP switch #3 is „ON", messages of not learned devices or key combinations will not be repeated. In order to learn devices
or key combinations set the DIP switch # 2 to „ON". The Learn mode can be left by setting the DIP switch #2 in its initial position.
Switching in learn mode or between different learn modes takes a few seconds.
DIP switch #3 and #4 determine different actions that can be done as soon as the repeater has entered into learn mode. Following
table provides an overview of the different configuration possibities and their signalization.
DIP switch nr.
Description
2 3 4
ON Every transmitter key will be learned
ON ON Specific transmitter key combination will be learned.
All entries of the corresponding sending transmitter will be
ON ON
erased
ON ON ON All entries will be erased
For the first three learn or erase modes it is necessary that a corresponding transmitter signal has been received.
6 Technical Data
Working frequency:
Antenna:
Supply voltage :
Current consumption:
Ambient temperature:
Connections:
Case:
Initial position
Repeater operation mode
All messages will be repeated
Messages will always be repeated
Continuous active operation mode
n.a.
f1 433,62 MHz; f2 434,22 MHz
Integrated antenna
5,0...16,0 V DC
Stand By 20mA (LCC Mode Stand By 4 mA)
-20°C to +65°C
Screw terminals on the inside
85mm x 85mm x 37mm; IP55
Position ON
f2 = 434,22 MHz
Learn-/Erase mode = Learn or erase a device or key
combination
Messages only be repeated if device or key
combination has been learned before
Messages will not be repeated if the radio
communication is already succesful
After 10min without any action the repeater switches
in clocked operation mode in order to reduce the
current consumption
n.a.
Signalization
The light of the LED T interrupts 1x every second.
The light of the LED T interrupts 2x every second.
The light of the LED T flashes 1x every second.
LED T and LED R flashes a several times. Subsequently
both led's switch off.
- -
5