Changing The Saw Blade; Use; Switching The Appliance On And Off; Switching The Work Lamp On And Off - Parkside PMB 1100 B2 Originalbetriebsanleitung

Adjusting the workpiece stop
■ During normal operation, the workpiece stop
must be fixed in the lowest position.
♦ If the workpiece stop
sawing, you can undo the workpiece stop
screw to remove it. Use the supplied hex
key to do this. In this way, you can adjust the
workpiece stop
stop in place again using the workpiece stop
screw .

Changing the saw blade

WARNING! RISK OF INJURY!
► Wear protective gloves to avoid injury.
♦ Release the saw blade clamping lever
turning it anticlockwise
♦ Remove the two locking screws
supplied small hex key
protective covers
♦ Carefully remove the saw blade
guide rollers (see fig. B on the fold-out
page).
♦ Remove any sawdust with a brush or
compressed air.
♦ Slide the saw blade
with the saw teeth pointing upwards. Make sure
that the guide rollers
saw blade .
NOTE
► Make sure that the direction arrow on the
saw blade (if any) is the same as the one
on the rubber wheels
│ GB │ IE
■ 20
gets in the way when
upwards. Fix the workpiece
.
with the
. Remove the two
.
. Start at the
into the guide rollers
completely grip the
.
♦ Insert the saw blade
wheels.
♦ Retighten
turning it clockwise
♦ Replace the two protective covers
WARNING! RISK OF INJURY!
► Only operate the appliance with the
protective covers fitted
♦ Perform a test run by briefly switching the appli-
ance on and off a few times to determine
whether the saw blade is correctly seated.
WARNING! RISK OF INJURY!
►
Keep your body away from the sawing
by
area during the test run!

Use

Switching the appliance on and off
Switching on
♦ Hold down the On/Off switch
Switching off
♦ Release the On/Off switch
Switching the work lamp on and off
Switching on
♦ Move the light switch
The work lamp
Switching off
♦ Move the light switch
The work lamp

Setting rotational speed

♦ Adjust the speed setting wheel
between 1 and 6.
around the two rubber
the saw blade clamping lever
again.
!
.
.
to position I.
lights up.
to position 0.
goes out.
to a position
PMB 1100 B2
by
.