Introduction; Intended Use; Features; Package Contents - Parkside PMB 1100 B2 Originalbetriebsanleitung

PORTABLE METAL BAND SAW
PMB 1100 B2

Introduction

Congratulations on the purchase of your new
appliance. You have chosen a high-quality product.
The operating instructions are a part of this product.
They contain important information about safety,
usage and disposal. Before using the product,
please familiarise yourself with all of the operating
and safety instructions. Use the product only as
described and for the range of applications speci-
fied. Please also pass these operating instructions
on to any future owner.

Intended use

The appliance is primarily intended for sawing
metal pipes or profiles.
Any other usage or modification of the appliance is
deemed to be improper and carries a significant
risk of accidents.
The appliance should not be used for industrial
purposes.

Features

Light switch
Speed setting wheel
On/Off switch
Workpiece stop
Workpiece stop screw
Small hex key
Saw blade
Saw blade clamping lever
Figure A
Handle
Wing screw on handle
Protective covers
Locking screws
Figure B
Rubber wheels
Guide rollers
│ GB │ IE
■ 14
Figure C
Handle on the vice
Quick release
15a
Vice
Cylinder head screws with hex socket
Figure D
Cutting angle adjustment
Long wing screw
Screw for the cutting angle adjustment
Locking pin
Nut
21a
Swivel arm
Figure E
Work lamp
Saw table

Package contents

1 portable Metal Band Saw
1 saw table (pre-assembled)
4 wing screws, long
4 cylinder head screws with hex socket
1 hex key, small (4 mm)
1 hex key, large (6 mm)
1 set of operating instructions
Technical specifications
Rated voltage
Rated power consumption 1100 W
Cutting width at 90°
Cutting width at 45°
Rated idle speed
Saw band speed
Inclined cuts
Protection class
230 V ∼, 50 Hz (AC)
127 mm x 127 mm
(without saw table)
127 mm x 40 mm
(without saw table)
n 0–290 rpm
0
0–2.4 m/s
0°–45°
II / (double insulation)
PMB 1100 B2